Wheel Bearing and Wheel Hub
Wheel Bearing and Wheel HubService Repair No - 64.15.14
Special Service Tools
Removal
1. WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
Raise and support the vehicle.
2. Remove the rear wheels and tires
3. Remove the wheel knuckle.
4. Release the brake disc shield.
^ Remove the 4 bolts.
5. NOTE: The bearing track will remain on the wheel hub.
Using the special tools, remove the wheel hub.
6. Remove the brake disc shield.
7. Remove the special tools.
8. Using the special tools, press out the rear wheel bearing.
^ Remove and discard the circlip.
9. Using a bearing separator and the special tool, remove the rear wheel bearing inner track.
Installation
1. Using the special tools, install the rear wheel bearing.
^ Clean the component mating faces.
^ Install a new circlip.
2. Install the brake disc shield.
^ Clean the component mating faces.
^ Tighten the M8 bolts to 25 Nm (18 ft. lbs.).
^ Tighten the M6 bolts to 10 Nm (7 ft. lbs.).
3. Using the special tools, press the wheel hub into the rear wheel bearing.
^ Clean the component mating faces.
4. Install the wheel knuckle.
5. Install the wheels and tires.
^ Tighten the wheel nuts to 140 Nm (103 ft. lbs.).