Front Seat Backrest Lower Rear Cover

Front Seat Backrest Lower Rear Cover

Removal

WARNING:
^ Persons working on the supplemental restraint system (SRS) must be fully trained and have been issued with the safety guidelines.
^ Allow a period of 10 minutes to elapse after disconnecting the battery before undertaking any work on the SRS.
^ The SRS electrical connectors are unique. DO NOT force, or attempt to connect electrical connectors to the wrong sockets.
^ The correct procedures must always be used when working on SRS components.
^ It is imperative that before any work is undertaken on the SRS system, the appropriate information is read thoroughly.
^ Always disconnect both battery cables before beginning work on the SRS system. Disconnect the ground cable first. Never reverse connect the battery.
^ Take extra care when handling SRS components.

1. Disconnect the battery ground cable.
2. Make the air bag supplemental restraint system (SRS) safe.
3. Remove the front seat.
4. Release the 2 lower tension straps from the front seat base.
^ Reposition the front seat backrest cover for access.







5. Remove the front seat side trim panel support.
^ Release the 2 clips.







6. Remove the seat control switch.
7. Remove the front seat backrest hinge cover.
^ Remove the 2 screws.
^ Release the clip.







8. NOTE: Left-hand shown, right-hand similar.

Remove the 2 clips from the front seat backrest lower rear cover.







9. Remove the front seat backrest lower rear cover.
^ Release the front seat backrest cover lower trim panel from the 2 clips.







Installation

1. Install the front seat backrest lower rear cover.
^ Secure the front seat backrest cover lower trim panel to the 2 clips.

2. Install the 2 clips to the front seat backrest lower rear cover.
3. Install the front seat backrest hinge cover.
^ Secure the clip.
^ Install the 2 screws.

4. Install the seat control switch.
5. Install the front seat side trim panel support.
^ Secure the 2 clips.

6. Secure the 2 lower tension straps to the front seat base.
^ Reposition the front seat backrest cover.

7. Install the front seat.
8. Connect the battery ground cable.