Audio Unit

Audio Unit

Removal

WARNING:
- Persons working on the supplemental restraint system (SRS) must be fully trained and have been issued with the safety guidelines.
- Allow a period of 10 minutes to elapse after disconnecting the battery before undertaking any work on the SRS.
- The SRS electrical connectors are unique. DO NOT force, or attempt to connect electrical connectors to the wrong sockets.
- The correct procedures must always be used when working on SRS components.
- It is imperative that before any work is undertaken on the SRS system, the appropriate information is read thoroughly.
- Always disconnect both battery cables before beginning work on the SRS system. Disconnect the ground cable first. Never reverse connect the battery.
- Take extra care when handling SRS components.

1. Make the air bag supplemental restraint system (SRS) safe.
2. Disconnect the battery ground cable.
3. Remove the lower glove compartment.
4. Release the audio unit.
- Remove the 4 screws.
- Release the wiring harness clip.







5. Remove the audio unit.
- Disconnect the 2 electrical connectors.
- Disconnect the coaxial cable connector.
- Disconnect the optical connector.







NOTE: Do not disassemble further if the component is removed for access only.

6. Disassemble the audio unit from the carrier bracket.
- Remove the 4 screws.
- Remove the audio unit.







Installation
1. Assemble the audio unit to the carrier bracket.
- Install the screws.

2. Install the audio unit.
- Connect the electrical connectors.
- Connect the coaxial cable connector.
- Connect the optical connector.

3. Secure the audio unit.
- Secure the wiring harness clip.
- Install the screws.

4. Install the lower glove compartment.
5. Connect the battery ground cable.