Crankshaft Position Sensor: Service and Repair

Crankshaft Position (CKP) Sensor

Removal
1. Disconnect the battery ground cable.

WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.

2. Raise and support the vehicle.
3. Remove the engine undershield.

CAUTION: Before the disconnection or removal of any components, ensure the area around joint faces and connections are clean. Plug any open connections to prevent contamination.

4. Remove the crankshaft position (CKP) sensor.
^ Disconnect the electrical connector.
^ Remove the bolt.





Installation
1. To install, reverse the removal procedure.
^ Tighten the bolt to 10 Nm (7 ft. lbs.).