Supercharger: Service and Repair

Supercharger

Removal
1. Disconnect the battery ground cable.

WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.

2. Raise and support the vehicle.
3. Remove the coolant manifold.
4. Remove the throttle body elbow.
5. Position the throttle body intake spigot and wiring harness aside.
^ Remove the bolt.

6. Remove the supercharger.
^ Remove the 3 bolts.







Installation
1. Install the supercharger.
^ Clean the component mating faces.
^ Clean the locating dowels.
^ Tighten the bolts to 25 Nm (18 ft. lbs.).

2. Install the throttle body intake spigot.
^ Tighten the bolt to 25 Nm (18 ft. lbs.).

3. Install the throttle body elbow.
4. Install the coolant manifold.
5. Connect the battery ground cable.
6. Refill and bleed the cooling system.