Windshield Wiper Motor

Windshield Wiper Motor

Service Repair No - 84.15.12

Removal

1. Disconnect the battery ground cable.
2. Remove the windshield wiper motor.
^ Mark the position of the windshield wiper motor linkage to aid assembly.
^ Remove the windshield wiper motor to windshield wiper motor linkage assembly nut.
^ Release the wiper linkage assembly from the windshield wiper motor.
^ Remove the 3 windshield wiper motor to support bracket bolts.
^ Disconnect the electrical connector.







Installation

1. Install the windshield wiper motor.
^ Tighten the bolts to 10 Nm (7 ft. lbs.).
^ Connect the electrical connector.

2. Carry out the windshield wiper motor park operation.
^ Connect the battery ground cable.
^ Turn the ignition key to the ON position and make sure the windshield wiper motor is in the park position, turn the ignition key to the OFF position.
^ Disconnect the battery ground cable.

3. Install the windshield wiper motor and linkage.
^ Reposition the windshield wiper motor linkage to its original position.
^ Install the windshield wiper motor to windshield wiper motor linkage assembly nut.
^ Tighten the nut to 25 Nm (18 ft. lbs.).

4. Connect the battery ground cable.