Rear Door Window Motor: Service and Repair

Rear Door Window Regulator and Motor

Service Repair No - 86.25.05

Special Service Tools





Removal

NOTE: The door glass should be lowered by approximately one third.

1. Remove the rear door speaker.
2. Carefully remove the outer waist seal.
^ Remove the screw.





3. NOTE: Wedge the glass in this position.

^ Using the special tool, release the clip and lift the glass to the top of the door frame.





4. Remove the window motor and regulator assembly.
^ Disconnect the electrical connector.
^ Remove the 4 bolts.
^ Remove the 2 nuts.
^ Rotate the assembly by approximately 45 degrees, to remove the assembly from the rear side of the aperture first.





Installation

1. Install the window motor and regulator assembly.
^ Tighten the bolts and nuts to 10 Nm (7 ft. lbs.).
^ Connect the electrical connector.

2. Secure the glass to the glass regulator.
^ Remove the wedge.
^ Lower the glass.

3. Install the outer waist seal.
^ Tighten the Torx screw.

4. Install the rear door speaker.