Selector Lever Assembly
Selector Lever AssemblyService Repair No - 44.15.04
Removal
1. Disconnect the battery ground cable.
2. WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
2. Raise and support the vehicle.
3. Remove the transmission undershield.
^ Remove the 6 bolts.
4. If installed, remove the transmission heat shield.
^ Remove the 4 bolts.
5. Release the selector cable.
^ Using an additional wrench, restrain the clamping bush and loosen the locknut.
^ Compress the latch and release the cable.
6. Remove the floor console upper panel.
7. Release the transmission selector lever.
^ Disconnect the electrical connector.
^ Remove the 4 bolts.
8. Remove the transmission selector lever mount bracket.
^ Remove the 4 bolts.
9. Remove the transmission selector lever.
^ Release the selector cable from the body.
Installation
1. Install the selector lever cable.
2. Install the transmission selector lever mount bracket.
^ Tighten the bolts to 10 Nm (7 lb.ft).
3. Install to the selector lever.
^ Connect and secure the electrical connector.
^ Install the bolts and tighten to 10 Nm (7 lb.ft).
4. NOTE: Do not tighten the locking nut at this stage.
Connect the selector cable to the transmission.
^ Engage the inner cable with the lever clamping bush.
^ Install the selector cable to its abutment bracket.
5. Install the floor console upper panel.
6. Adjust the selector cable.
7. If installed, install the transmission heat shield.
^ Tighten the bolts to 10 Nm (7 lb.ft).
8. Install the transmission undershield.
^ Tighten the bolts to 10 Nm (7 lb.ft).
9. Connect the battery ground cable.