Ride Height Sensor: Service and Repair
Suspension Height SensorService Repair No - 60.36.01
Removal
NOTE: The rear height sensors are handed. The right hand sensor has a black colored lever and the left hand sensor has a white colored lever. The front height sensors are not handed, and are fitted with grey levers for identification.
NOTE: This procedure covers removal and installation of both the front and rear suspension height sensors.
1. WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
Raise and support the vehicle.
2. Remove the wheel and tire.
3. CAUTION: Do not use excessive force to disconnect the height sensor link.
Disconnect the height sensor link.
4. NOTE: Front suspension height sensor shown, rear similar.
Remove the suspension height sensor.
^ Disconnect the electrical connector.
^ Remove the 2 Torx screws.
Installation
1. To install, reverse the removal procedure.
^ Tighten the screws to 2.2 Nm (1.5 ft. lbs.).
2. CAUTION: Height suspension calibration, using T4, must always be carried out if the suspension height sensor fixings are removed.
Using T4, calibrate the ride height.