Dynamic Response Module
Dynamic Response ModuleService Repair No - 60.60.01
Removal
NOTE: The dynamic response module is always located on the driver's side of the vehicle.
1. Remove the cowl side trim panel.
2. Remove the closing trim panel.
^ Release the clip.
^ Remove the 2 screws.
^ Disconnect the electrical connector.
3. Remove the dynamic response module.
^ Remove the 2 bolts.
^ Disconnect the 2 electrical connectors.
Installation
1. Install the dynamic response module.
^ Connect the electrical connectors.
^ Tighten the 2 bolts to 4 Nm (3 lb.ft).
2. Install the closing trim panel.
^ Connect the electrical connector.
^ Secure the clip.
^ Tighten the screws.
3. Install the cowl side trim panel.
4. Initiate a new control module using T4.