Inspection and Verification

Inspection and Verification

1. Verify the customer concern.
2. Visually inspect for obvious electrical faults.

Mechanical Electrical
^ Lighting control ^ Fuses Battery junction box (BJB) - link switch and fitment
^ 15E BJB - link 16E BJB - link 11E BJB - link 25E Central junction box (CJB) - Fuse 18P CJB - Fuse 67P CJB - Fuse 62P
^ Rain/Light sensor ^ Relays Automatic headlamps relay
condition and fitment
^ Wiper control ^ Wiring harness
switch and fitment
^ Loose or corroded connector(s)
^ Battery junction box (BJB)
^ Central junction box (CJB)
^ Rain/Light sensor control module
^ Local interconnect network (LIN) circuits
^ Controller area network (CAN) circuits

3. If an obvious cause for an observed or reported concern is found, correct the cause (if possible) before proceeding to the next step.
4. . Use the approved diagnostic system or a scan tool to retrieve any diagnostic trouble codes (DTCs) before moving onto the symptom chart or DTC index.
^ Because the DTCs are stored in more than one module, a complete vehicle read is recommended
^ Make sure that all DTCs are cleared the rectification