Part 2

The content of this article/image reflects the changes identified in Land Rover TSB - LTB00143

Crankshaft Main Bearing Carrier

Service Repair No - 12.21.42

Removal - Part 2
53. Remove the RH primary timing chain.





54. Remove the LH VCT housing.
^ Remove the 3 bolts.
^ Remove and discard the 0-ring seals.





55. Install the special tool to the LH cylinder head.
^ Install the 3 bolts.





56. Remove the LH primary timing chain tensioner.
^ Remove the 2 bolts.





57. Remove the LH upper and lower primary timing chain tensioner guides.
^ Remove the 2 bolts.





58. Remove the LH primary timing chain.





NOTE: Note the orientation of the crankshaft sprocket.

59. Remove the crankshaft sprocket.
^ Remove the crankshaft sprocket key.





60. Remove the special tool.





CAUTION: The bolts can only be used 3 times, mark the bolts with a center punch. If 2 punch marks are visible, discard the bolts.

61. Remove the torque converter flexplate.
^ Remove the 8 bolts.





CAUTION: Note the position of the bolts, prior to removal.

62. Remove the oil pan.
^ Remove the 17 bolts.
^ Remove and discard the gasket.





63. Remove the oil strainer pick-up assembly.
^ Remove the 2 bolts.
^ Remove and discard the 0-ring seal.





64. Remove the oil pan extension.
^ Remove the 18 bolts.





65. Remove the oil pump assembly. Remove the 4 bolts.
^ Remove and discard the gasket.
^ Clean the component mating faces.





66. Remove the baffle plate.
^ Remove the 6 bolts.





CAUTION: To make sure damage does not occur to the crankshaft and piston components, the engine must be inverted on the engine stand. Failure to follow this instruction may result in damage to the engine.

NOTE: If the crankshaft main bearing carrier retaining bolts have been marked with a center punch dot, they must be discarded and new bolts installed.

67. Remove the crankshaft main bearing carrier.
^ Remove the crankshaft main bearing carrier retaining bolts in the indicated sequence.





68. Discard the crankshaft rear main oil seal.