D-Pillar Trim Panel

D-Pillar Trim Panel

Service Repair No - 76.13.30

Removal

1. Remove the lower quarter trim panel.

2. NOTE: Left-hand shown, right-hand similar.

With assistance, remove the rear seat assembly.
^ Remove and discard the 7 Torx bolts.
^ Disconnect the electrical connector.





3. Remove the safety belt lower anchor.
^ Remove and discard the Torx bolt.





4. Remove the D-pillar trim panel.
^ Release the 4 clips.
^ Release the safety belt from the trim panel.





5. NOTE: Do not disassemble further if the component is removed for access only.

Remove the 4 clips from the D-pillar upper trim panel.





Installation

1. Install the clips to the D-pillar upper trim panel.
2. Install the D-pillar upper trim panel.
^ Position the safety belt through the trim panel.
^ Secure the clips.

3. Install the safety belt lower anchor.
^ Tighten the Torx bolt to 45 Nm (33 ft. lbs.).

4. With assistance, install the rear seat assembly.
^ Position the locating pegs.
^ Connect and secure the electrical connector.
^ Tighten the Torx bolts to 40 Nm (30 ft. lbs.).

5. Install the lower quarter trim panel