Loadspace Trim Panel LH

Loadspace Trim Panel LH

Service Repair No - 76.19.21

Removal

1. Remove the loadspace floor panels.
^ Lift and remove the front panel.
^ Lift and remove the rear panel.





2. Remove the loadspace compartment anchors.
^ Remove the bolt.
^ Repeat the above procedure for the other anchor.





3. Remove the loadspace trim panel.
^ Release the 3 clips.





4. NOTE: Do not disassemble further if the component is removed for access only.

Remove the 2 clips.





Installation

1. Install the clips.
2. Install the loadspace trim panel.
^ Secure the clips.
^ Position the locating pegs.

3. Install the loadspace compartment anchors.
^ Position the locating peg.
^ Tighten the bolt to 25 Nm (18 ft. lbs.).
^ Repeat the above procedure for the other anchor.

4. Install the loadspace floor panels.