Throttle Body Gasket

Throttle Body Gasket

Removal
1. Disconnect the battery ground cable.
2. Remove the engine cover.
3. Remove the air intake resonator.
4. Position the wiring harness support bracket aside.
^ Release the 2 fuel pipe clips.
^ Remove the 4 bolts.





5. Remove the throttle body intake.
^ Disconnect the breather line.
^ Release the clip.
^ Release the bushing.

CAUTION: Before disconnecting or removing the components, ensure the area around the joint faces and connections are clean. Plug open connections to prevent contamination.

6. Release the wiring harness clip.





7. Disconnect the throttle position (TP) sensor electrical connector.
8. Release the throttle body.
^ Remove the 4 bolts.
^ Remove and discard the throttle body gasket.





Installation
1. Install the throttle body.
^ Clean the components.
^ Install a new gasket.
^ Tighten the 4 bolts to 10 Nm (7 ft. lbs.).

2. Connect the TP sensor electrical connector.
3. Secure the wiring harness clip.
4. Clean the component mating faces.
5. Install the throttle body intake.
^ Align the bushing.
^ Secure the clip.
^ Connect the breather line.

6. Install the wiring harness support bracket.
^ Tighten the bolts to 10 Nm (7 ft. lbs.).

7. Install the air intake resonator.
8. Install the engine cover.
9. Connect the battery ground cable.