Transmission Fluid Level Check
Transmission Fluid Level CheckService Repair No - 44.24.06
WARNING: Observe due care when draining transmission fluid as the fluid can be very hot.
WARNING: Observe due care when working near a hot exhaust system.
CAUTION: The gearbox fluid level must only be checked when the temperature of the fluid is between 30 degrees C and 50 degrees C (86-122°F). The fluid level obtained will be incorrect if the reading is outside this temperature range.
1. These steps must be observed before starting the transmission fluid level check and top-up.
^ The vehicle must be on a horizontal ramp.
^ The parking brake must be applied.
^ The wheels must be chocked.
2. CAUTION: Make sure the transmission fluid temperature is below 30 degrees C (86°F) before starting the fluid level check.
Connect T4 to the on-board diagnostic connector to monitor the transmission fluid temperature.
3. Start the engine. Move the selector lever from 'P' through all gear positions, pausing in each gear position for 2-3 seconds and return to the 'P' position.
4. WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
Raise and support the vehicle.
5. Place a container under the transmission.
6. WARNING: Observe due care when draining transmission fluid as the fluid can be very hot.
WARNING: Observe due care when working near a hot exhaust system.
CAUTION: The gearbox fluid level must only be checked when the temperature of the fluid is between 30 degrees C and 50 degrees C (86-122°F). The fluid level obtained will be incorrect if the reading is outside this temperature range.
Remove the transmission fluid filler/level plug.
^ Clean the area around the filler/level plug.
^ Remove and discard the sealing washer.
7. If no fluid loss is apparent when the filler/level plug is removed, with the engine at idle, continue to fill the transmission until a small thread of oil runs from oil filler/level hole.
8. Install the transmission fluid filler/level plug and tighten to 35 Nm (26 ft. lbs).
^ Install a new sealing washer.
^ Remove the container.
9. Disconnect T4 from the vehicle.