Front Lower Arm Bushing
Front Lower Arm BushingService Repair No - 60.35.26
Special Service Tools
Removal
NOTE: bushes must be replaced as a pair
1. Raise and support the vehicle.
2. Remove the wheels and tires.
3. LH front: Release the suspension height sensor link.
4. Release the LH front lower arm.
^ Remove and discard the bolt.
5. Using the special tools, remove the front lower arm bushes.
Installation
1. Using the special tools, install the front lower arm bushes.
2. WARNING: Make sure that a new bolt is installed.
CAUTION: Only tighten the nuts and bolts when the suspension is in the normal drive position.
Secure the LH front lower arm.
^ Tighten the nut and bolt to 165 Nm (121 ft. lbs.). plus a further 90 degrees.
3. LH front: Secure the suspension height sensor link.
4. Repeat the above procedure for the RH side.
5. Install the wheels and tires.
^ Tighten the wheel nuts to 140 Nm (103 ft. lbs.).
6. Check, and if necessary, adjust the wheel alignment.