Horn Switch: Service and Repair

Horn Switch

Service Repair NO - 86.30.01

Removal

WARNING:
^ Persons working on the supplemental restraint system (SRS) must be fully trained and have been issued with the safety guidelines.
^ Allow a period of 10 minutes to elapse after disconnecting the battery before undertaking any work on the SRS.
^ The SRS electrical connectors are unique. DO NOT force, or attempt to connect electrical connectors to the wrong sockets.
^ The correct procedures must always be used when working on SRS components.
^ It is imperative that before any work is undertaken on the SRS system, the appropriate information is read thoroughly.
^ Always disconnect both battery cables before beginning work on the SRS system. Disconnect the ground cable first. Never reverse connect the battery.
^ Take extra care when handling SRS components.

1. Make the air bag supplemental restraint system (SRS) safe.
2. Disconnect the battery ground cable.
3. Remove the driver air bag module.

NOTE: Left-hand shown, right-hand similar.

4. Remove the horn switch.
^ Disconnect the 3 electrical connectors.
^ Remove the 2 screws.





Installation
1. Install the horn switch.
^ Connect the 3 electrical connectors.
^ Install the 2 screws and tighten to 3 Nm (2 ft. lbs.).
2. Install the driver air bag module.
3. Connect the battery ground cable.