Front Seat Cushion Heater and Blower Assembly

Front Seat Cushion Heater And Blower Assembly

Removal

WARNING:
^ Persons working on the supplemental restraint system (SRS) must be fully trained and have been issued with the safety guidelines.
^ Allow a period of 10 minutes to elapse after disconnecting the battery before undertaking any work on the SRS.
^ The SRS electrical connectors are unique. DO NOT force, or attempt to connect electrical connectors to the wrong sockets.
^ The correct procedures must always be used when working on SRS components.
^ It is imperative that before any work is undertaken on the SRS system, the appropriate information is read thoroughly.
^ Always disconnect both battery cables before beginning work on the SRS system. Disconnect the ground cable first. Never reverse connect the battery.
^ Take extra care when handling SRS components.

1. Disconnect the battery ground cable.
2. Make the air bag supplemental restraint system (SRS) safe.
3. Remove the front seat cushion and front seat cushion cover from the front seat base.
4. Reposition the front seat base wiring harness trim panel.
^ Reposition the front seat for access.
^ Remove the 4 screws.







5. Remove the front seat cushion heater and blower motor assembly duct.
^ Remove the screw.







6. Remove the 3 screws from the front seat heater and blower motor assembly.







7. Remove the front seat cushion heater and blower motor assembly.
^ Disconnect the front seat cushion heater and blower motor assembly electrical connector.







Installation

1. Install the front seat cushion heater and blower motor assembly.
^ Connect the front seat cushion heater and blower motor assembly electrical connector.

2. Install the 3 screws to the front seat cushion heater and blower motor assembly.
3. Install the front seat cushion heater and blower motor assembly duct.
^ Install the screw.

4. Reposition the front seat base wiring harness trim panel.
^ Reposition the front seat for access.
^ Install the 4 screws.

5. Install the front seat cushion and cover to the front seat base.
6. Connect the battery ground cable.