Front Seat Recliner Motor

Front Seat Recliner Motor

Service Repair No - 78.70.34

Removal

WARNING:
^ Persons working on the supplemental restraint system (SRS) must be fully trained and have been issued with the safety guidelines.
^ Allow a period of 10 minutes to elapse after disconnecting the battery before undertaking any work on the SRS.
^ The SRS electrical connectors are unique. DO NOT force, or attempt to connect electrical connectors to the wrong sockets.
^ The correct procedures must always be used when working on SRS components.
^ It is imperative that before any work is undertaken on the SRS system, the appropriate information is read thoroughly.
^ Always disconnect both battery cables before beginning work on the SRS system. Disconnect the ground cable first. Never reverse connect the battery.
^ Take extra care when handling SRS components.

1. Disconnect the battery ground cable.
2. Make the air bag supplemental restraint system (SRS) safe.
3. Remove the front seat backrest cover.
4. Reposition the front seat backrest shaft.
^ Remove and discard the front seat backrest shaft clip.







5. Remove the front seat recliner motor.
^ Disconnect the electrical connector.
^ Remove the front seat recliner motor bolt.







6. Remove the front seat recliner motor bracket.
^ Release the 2 clips.







Installation

1. Install the front seat recliner motor bracket.
^ Secure the 2 clips.

2. Install the front seat recliner motor.
^ Loosely install the front seat recliner motor bolt.
^ Connect the electrical connector.

3. Reposition the front seat backrest shaft.
^ Install the new front seat backrest shaft clip.
^ Tighten the front seat recliner motor bolt.

4. Install the front seat backrest cover.
5. Make the air bag supplemental restraint system (SRS) safe.
6. Connect the battery ground cable.