Floor Console

Floor Console

Service Repair No - 76.25.01

Removal

1. Disconnect the battery ground cable.
2. Remove the LH front seat.
3. Remove the LH floor wiring harness trim panel.
^ Remove the 2 clips.







4. Reposition the floor console wiring harness.
^ Disconnect the 4 electrical connectors.
^ Reposition the carpet for access.







5. Remove the selector lever knob.
6. Remove the LH floor console extension.
7. Remove the RH floor console extension.
^ Remove the screw.
^ Release the 2 clips.

8. NOTE: Left-hand shown, right-hand similar.

Remove the 2 front bolts from the floor console.







9. Remove the climate controlled seat switch trim panel.
^ Carefully release the 4 clips.
^ Remove the 2 front screws from the floor console upper panel.







10. Remove the rear floor register.
^ Release the 4 clips.







11. NOTE: Left-hand shown, right-hand similar.

Remove the 2 rear bolts from the floor console.
^ Remove the floor console rear LH floor register.
^ Remove the floor console rear LH bolt.
^ Remove the floor console rear RH floor register.
^ Remove the floor console rear RH bolt.







12. Remove the floor console.
^ Reposition the floor console upwards and rearwards.







13. Remove the auxiliary climate control rear register.
14. Remove the cellular phone cradle assembly lower trim panel.
^ Reposition the cellular phone cradle assembly.
^ Remove the 6 screws.







15. Remove the cellular phone cradle assembly.
^ Disconnect the 2 electrical connectors.
^ Release the 2 electrical connectors from the clips.







16. Remove the floor console stowage compartment.
^ Open the floor console stowage compartment lid.
^ Remove the 2 screws.
^ Carefully release the 2 clips.
^ Disconnect the cigar lighter electrical connector.







17. CAUTION: Make sure damage does not occur to the vehicle trim when removing the centre console side finisher trim panel.

NOTE: Left-hand shown, right-hand similar.

Remove the center console LH side finisher trim panel
^ Using a suitable tool, carefully release the 3 clips.







18. CAUTION: Make sure damage does not occur to the vehicle trim when removing the centre console side finisher trim panel.

Remove the center console RH side finisher trim panel.
^ Using a suitable tool, carefully release the 3 clips.

19. Reposition the floor console upper panel.
^ Remove the 4 screws.
^ Using a suitable tool, carefully release the 4 clips.







20. Disconnect the parking brake switch electrical connector.







21. Remove the floor console upper panel.
^ Release the 3 wiring harness clips.
^ Disconnect the 3 electrical connectors.







22. Disconnect the 6 electrical connectors from the rear passenger entertainment control panel.







23. NOTE: Do not disassemble further if the component is removed for access only.

Remove the floor console rear trim panel.
^ Remove the 4 screws.







24. Remove the rear auxiliary climate control assembly.
^ Remove the 4 screws.
^ Disconnect the 2 electrical connectors.







25. NOTE: Left-hand shown, right-hand similar.

Remove the floor console LH finisher trim panel.
^ Remove the 11 screws.







26. Remove the floor console RH finisher trim panel.
^ Remove the 11 screws.

27. Remove the 14 clips from the floor console.
28. Remove the 2 brackets from the floor console.
^ Remove the 2 screws.

Installation

1. Install the 2 brackets to the floor console.
^ Install the 2 screws.

2. Install the 14 clips to the floor console.
3. Install the floor console LH finisher trim panel.
^ Install the 10 screws.

4. Install the floor console RH finisher trim panel.
^ Install the 10 screws.

5. Install the rear auxiliary climate control assembly.
^ Connect the 2 electrical connectors.
^ Install the 4 screws.

6. Install the floor console rear trim panel.
^ Install the 4 screws.

7. Connect the 6 electrical connectors to the rear passenger entertainment control panel.
8. Install the floor console upper panel.
^ Connect the 3 electrical connectors.
^ Attach the 3 wiring harness clips.

9. Connect the parking brake switch electrical connector.
10. Reposition the floor console upper panel.
^ Secure the 4 clips.
^ Install the 4 screws.

11. Install the center console LH side finisher trim panel.
^ Secure the 3 clips.

12. Install the center console RH side finisher trim panel.
^ Secure the 3 clips.

13. Install the floor console stowage compartment.
^ Connect the cigar lighter electrical connector.
^ Secure the 2 clips.
^ Install the 2 screws.
^ Close the floor console stowage compartment lid.

14. Install the cellular phone cradle assembly.
^ Attach the 2 electrical connectors to the clips.
^ Connect the 2 electrical connectors.

15. Install the cellular phone cradle assembly lower trim panel.
^ Install the six screws.
^ Reposition the cellular phone cradle assembly.

16. Install the auxiliary climate control rear register.

17. CAUTION: Make sure the floor console is correctly located and installed. Failure to follow this instruction will result in damage to the vehicle trim.

Install the floor console.
^ Reposition the floor console to its original position.

18. Install the 2 rear bolts to the floor console.
^ Install the floor console rear RH bolt.
^ Install the floor console rear RH floor register.
^ Install the floor console rear LH bolt.
^ Install the floor console rear LH floor register.

19. Install the rear floor register.
^ Secure the 4 clips.

20. Install the climate controlled seat switch trim panel.
^ Install the 2 front screws to the floor console upper panel.
^ Secure the 4 clips.

21. Install the 2 front bolts to the floor console.
^ Install the floor console front RH bolt.
^ Install the floor console front LH bolt.

22. Install the LH floor console extension.
23. Install the RH floor console extension.
^ Install the screw.
^ Secure the 2 clips.

24. Install the selector lever knob.
25. Reposition the floor console wiring harness.
^ Reposition the carpet for access.
^ Connect the 4 electrical connectors.

26. Install the LH floor wiring harness trim panel.
^ Install the 2 clips.

27. Install the LH front seat.
28. Connect the battery ground cable.