Front Fender Liner: Service and Repair

Fender Splash Shield

Service Repair No - 76.10.48

Removal

1. WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.

Raise and support the vehicle.

2. Remove the front wheel.
3. Remove the front LH fender splash shield.
^ Remove the 3 nuts.
^ Remove the 13 screws.
^ Disconnect the tire pressure monitoring system front antenna electrical connector.







4. NOTE: Do not disassemble further if the component is removed for access only.

Remove the tire pressure monitoring system front antenna.
^ Release the 2 clips.

Installation

1. Install the tire pressure monitoring system front antenna.
2. Install the front LH fender splash shield.
^ Connect the tire pressure monitoring system front antenna electrical connector.
^ Tighten the screws.
^ Tighten the nuts.

3. Install the front wheel.
^ Tighten the wheel nuts to 140 Nm (103 ft. lbs.).