Power Operated Front Seats (Non-Memory)

Power Operated Front Seats (Non-memory)

NOTE:
^ The following operations require the ignition switch to be in position 1 or 2.
^ 8-way memory switch pack shown.





Forward/Backward adjustment
Push and hold the switch forwards or backwards to move the seat to the desired position.

Seat back adjustment
Twist the switch forwards or backwards until the desired seat back angle is achieved.

Seat cushion height adjustment
Push the switch up or down to raise or lower the cushion.

Front Seat Motors





The seat motors are a permanent magnet motor type coupled to a rack and pinion assembly. Should the motor seize or stick an internal thermal cut-out switch will trip to remove voltage from the motor. Two pins within each of the seat switch packs control the seat motors. Both pins are connected to ground. Operating the switch applies voltage to one of the pins while the other pin remains connected to ground. Operating the switch in the opposite direction reverses power and ground path to the motor allowing the motor to run in the opposite direction.