Roof Opening Panel Control Module

Roof Opening Panel Control Module

The roof opening panel control module is integrated within the motor. It takes the inputs from the vehicle, such as LIN (Local Interconnect Network) bus signals and switch signals, and controls motor movement appropriately. It also contains the algorithm for the anti-trap system.

Roof Opening Panel Control Module Pin Out Information





NOTE:
^ Pin 4 is for emergency use only, in the event of the vehicle LIN bus not being functional. It is not connected on the vehicle harness or in the connector.
^ Grounding pin 4 will enable the control module, but without one touch operation or anti trap. The panel will not require re-calibrating unless the battery has been disconnected (the control module will remain awake and enabled until pin 4 is disconnected again).
^ Under no circumstances is this pin to be left connected to ground for long periods.
^ There is no emergency key access in the roof-mounted console for manual operation should the motor fail for any reason.