B-Pillar Upper Trim Panel

B-Pillar Upper Trim Panel

Service Repair No - 76.13.28

Removal

1. Make the SRS system safe.
2. Remove the B-pillar lower trim panel.
3. Release the safety belt lower anchor from the seat.
^ Remove the bolt cover.
^ Passenger side, disconnect the electrical connector.
^ Remove the Torx bolt.





4. NOTE: Make sure the seat belt height adjuster is at its lowest point prior to removal of the B-pillar upper trim panel.

Remove the B-pillar upper trim panel.
^ Release the front and rear door weatherstrips for access.
^ Release the 2 lower clips, then the remaining upper clip.
^ Release the safety belt.





Installation

1. Install the B-pillar upper trim panel.
^ Secure with the clips.
^ Attach the safety belt.
^ Attach the door weatherstrips.

2. Attach the safety belt lower anchor to the seat.
^ Tighten the Torx bolt to 40 Nm (30 ft. lbs.).
^ Passenger side, connect the electrical connector.
^ Install the bolt cover.

3. Install the B-pillar lower trim panel.