Glass - Rear Door

Glass - Rear Door

Service Repair No - 76.31.02

Remove

1. Lower door glass.
2. Remove plastic sheet.







3. Remove 2 clips securing upper door frame finisher, disconnect anti trap multiplug and remove finisher.







4. Remove 3 Torx screws securing rear glass channel to door frame.
5. Withdraw glass channel from frame and position channel seal aside.







6. Remove Torx bolt securing glass to regulator.
7. Remove glass.

Refit

1. Position glass to regulator, fit bolt and tighten to 10 Nm (7 lbf.ft).
2. Fit glass channel to frame and secure with screws.
3. Fit and secure seal.
4. Connect multiplug, fit and secure upper finisher.
5. Fit plastic sheet.
6. Raise and lower glass to check operation.