Front Wheel

ABS Sensor - Front Wheel

Service Repair No - 70.65.30

Removal
1. Raise front of vehicle, one side.

WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.

2. Remove road wheel.





3. open cover on multiplug housing, release and disconnect sensor multiplug.





4. Release sensor lead from body bracket, clip and brake hose bracket.





5. Release sensor lead from damper, remove Allen screw and release ABS sensor from hub.

Installation
1. Clean ABS sensor, smear sensor with an anti-seize grease and fit sensor to hub.
2. Fit Allen screw securing ABS sensor and tighten to 8 Nm (6 ft. lbs.).
3. Secure sensor lead to damper, brake hose bracket, clip and body bracket then connect and secure multiplug. Close cover on multiplug housing.
4. Fit road wheel and tighten nuts to 140 Nm (103 ft. lbs.).
5. Remove stand and lower vehicle.
6. To ensure correct operation, the ABS system MUST be tested using T4.