Cover - One Piece - Front Seat Cushion - Models With Adjustable Upper Squab

Cover - One Piece - Front Seat Cushion - Models With Adjustable Upper Squab

Service Repair No - 78.30.02

Remove

1. Remove seat assembly.
2. Remove switch pack assembly.
3. Remove screw securing finisher on inner seat base, remove finisher.







4. Release 3 backboard tension straps from under seat.







5. Remove 2 screws securing lower squab finisher.
6. Release lower finisher from 6 retaining clips and remove.







7. Disconnect 2 tension straps securing upper squab cover.
8. Release velcro strip securing squab cover.







9. Release beading from squab cover finisher.
10. Release finisher from 4 retaining clips and remove.







11. If fitted: Disconnect headrest display unit multiplug and release harness from 4 clips.
12. Carefully release 2 retaining clips securing headrest to motor housing.
13. Remove headrest.







14. Release retaining strip securing squab cover to lower frame.







15. Disconnect multiplugs from headrest and upper squab motors.







16. Disconnect multiplugs from lumbar pump and valve.







17. Disconnect multiplug from heated seat circuit.
18. Release 2 retaining strips, securing both sides of lower squab cover to frame.
19. Release squab harness from 4 retaining clips.
20. Remove 2 Torx bolts securing squab frame to seat frame.
21. Remove squab assembly from seat assembly.







22. Release seat cover beading from sides and front of frame.
23. Remove seat cover and pad from frame.







24. Remove 15 hog rings securing cover to cushion, remove cover.

Refit

1. Position cover to cushion and secure with hog rings.
2. Position and secure cover and cushion assembly to frame.
3. Position and fit squab assembly to seat assembly.
4. Fit squab frame to seat frame, secure with Torx bolts tighten to 25 Nm (18 lbf.ft).
5. Fit retaining strips securing both sides of lower squab cover.
6. Connect multiplug to heated seat circuit.
7. Secure squab harness to retaining clips
8. Connect lumbar harness multiplugs to pump and valve.
9. Connect multiplugs to headrest and squab motor.
10. Fit retaining strip securing lower squab cover to frame.
11. Fit headrest and secure to motor housing.
12. If fitted: Connect headrest display unit multiplug and secure harness with clips.
13. Position upper finisher and secure retaining clips.
14. Secure squab cover beading to finisher.
15. Secure squab cover velcro strip
16. Connect tension straps securing upper squab cover.
17. Position lower finisher and secure retaining clips
18. Fit screws securing lower squab finisher.
19. Fit backboard tension straps to under seat retaining clips.
20. Position inner seat base finisher and secure with screw.
21. Fit switch pack assembly.
22. Fit seat assembly.