Trim Finisher - 'A' Post - Upper

Trim Finisher - 'A' Post - Upper

Service Repair No - 76.13.26

Before disconnecting the battery, ensure all text and cautions in the battery disconnection section are observed.

Remove

1. Make the SRS system safe.
2. Release door aperture seal.







3. Remove cover from screw.
4. Remove Torx screw securing 'A' post trim.
5. Release 3 clips securing 'A' post trim and remove trim.

CAUTION: The airbag is mounted directly under this finisher, extreme care is necessary.

6. Remove retaining clips from trim.

Refit

1. Fit retaining clips to trim.
2. Fit 'A' post trim and tighten screw to 2 Nm (1.5 lbf.ft).
3. Fit screw cover.
4. Fit seal to door aperture.
5. Connect battery leads, earth lead last.