Floor Console Upper Panel

Floor Console Upper Panel

Service Repair No - 76.25.11

Removal

1. Position the transmission selector lever into NEUTRAL.
^ Turn the ignition key to position II.
^ Press the brake pedal.

2. WARNING: The selector lever knob will be released suddenly, keep face clear during removal.

Remove the transmission selector panel.
^ Release the 8 clips.
^ Pull the selector lever knob upwards.
^ Disconnect the 4 electrical connectors.







3. Remove the ashtray.
^ Remove the ashtray insert.
^ Release the 4 clips.







4. Remove the floor console upper panel.
^ Remove the 6 Torx screws.
^ Release the 8 clips.
^ Disconnect the 2 electrical connectors.
^ Release the handbrake lever boot.







5. NOTE: Do not disassemble further if the component is removed for access only.

Remove the accessory socket.
^ Remove the 2 Torx screws.







6. Remove the cup holder.
^ Remove the 3 Torx screws.







Installation

1. Install the cup holder.
^ Tighten the Torx screws.

2. Install the accessory socket.
^ Tighten the Torx screws.

3. Install the floor console upper panel.
^ Secure in the clips.
^ Tighten the Torx screws.
^ Connect the electrical connectors.
^ Attach the handbrake lever boot.

4. Install the ashtray.
^ Secure in the clips.
^ Install the ashtray insert.

5. Install the transmission selector panel.
^ Connect the electrical connectors.
^ Secure with the clips.
^ Push the knob fully onto the selector lever.

6. Position the transmission selector lever into PARK.
^ Turn the ignition key to position II.
^ Press the brake pedal.