Floor Console

Floor Console

Service Repair No - 76.25.01

Removal

1. Remove the floor console side panels.
^ Remove the 2 Torx screws.
^ Release the 4 clips.







2. Remove the floor console upper panel.
3. Release the ignition switch from the floor console.
^ Remove the 2 Torx screws.







4. Remove the floor console rear panel.
^ Release the 6 clips.
^ If installed, disconnect 2 electrical connectors from the AVIO module.







5. Remove the cubby box liner.
6. Remove the floor console.
^ Remove the 4 Torx screws.
^ Remove the 2 Torx bolts.
^ Disconnect the 4 electrical connectors.







Installation

1. Install the floor console.
^ Tighten the Torx screws.
^ Tighten the Torx bolts to 10 Nm (7 ft. lbs.).
^ Connect the electrical connectors.

2. Install the cubby box liner.
3. Install the floor console rear panel.
^ Secure with the clips.
^ If installed, connect the electrical connectors to the AVIO module.

4. Attach the ignition switch to the floor console.
^ Tighten the Torx screws.

5. Install the floor console upper panel.
6. Install the floor console side panels.
^ Remove the 2 Torx screws.
^ Release the 4 clips.