Finisher - Console

Finisher - Console

Service Repair No - 76.25.07

Remove

1. Remove gear selector cover.







2. Release gaiter from handbrake lever grip.
3. Release and remove handbrake lever grip.
4. Open cubby box lids, carefully release clips and remove finisher.







5. Remove 6 Torx screws securing finisher to center console, fully apply handbrake.
6. Release finisher from clips, raise and disconnect 3 Lucar connectors from accessory power socket.
7. Disconnect multiplug from closing panel lamp assembly.
8. Remove center console finisher.

NOTE: Do not carry out further dismantling if component is removed for access only.

9. Remove 2 Torx screws securing accessory socket and remove socket.
10. Remove 4 Torx screws securing cubby box and remove box.
11. Remove 3 Torx screws securing cup holder and remove cup holder.
12. Remove handbrake lever gaiter

Refit

1. Fit cup holder and secure with Torx screws.
2. Fit cubby box and secure with Torx screws.
3. Fit accessory socket and secure with Torx screws.
4. Fit handbrake lever gaiter.
5. Position center console finisher and connect Lucars.
6. Connect multiplug to closing panel lamp assembly.
7. Fit finisher and secure with Torx screws.
8. Fit handbrake lever grip and secure gaiter.
9. Fit and secure small cubby box finisher.
10. Close cubby box lids.
11. Fit gear selector cover.