Centre Console

Center Console

Service Repair No - 76.25.01

Remove

1. Remove center console finisher.
2. Remove both center console closing panels.







3. Remove 2 Torx screws securing large cubby box liner, remove liner.







4. Remove 2 Torx screws securing ignition switch to center console.
5. Remove 4 Torx screws securing center console to fascia.







6. Remove 2 Torx screws and collect washers from base of large cubby box.







7. Remove 2 screws securing center console rear closing panel. Release clips and remove panel.







8. If fitted: Disconnect 2 multiplugs from AVIO module.
9. Raise rear of center console, disconnect 3 multiplugs from center console and collect air duct adaptor.
10. Disconnect 3 Lucar connectors from accessory power socket.
11. Carefully remove center console.

CAUTION: Care must be taken to protect painted and veneered surfaces.

Refit

1. Position center console and connect multiplugs to rear of console. Fit air duct adaptor and align center console to mountings.
2. Secure center console with screws.
3. If fitted: Connect multiplugs to AVIO module.
4. Fit rear closing panel and secure with clips and screws.
5. Position ignition switch and secure with screws.
6. Fit cubby box and secure with Torx screws.
7. Fit both center console closing panels.
8. Fit center console finisher.