Motor - Wiper - Tailgate

84.35.12 Motor - Wiper - Tailgate

Remove
1. Remove rear wiper arm.





2. Disconnect washer hose from wiper motor.
3. Disconnect multiplugs from wiper motor.
4. Remove 3 Torx screws securing rear wiper motor to tailgate.
5. Release motor from glass seal, remove motor assembly.
6. Remove seal from glass.

NOTE: Do not carry out further dismantling if component is removed for access only.

7. Remove compression limiters from wiper motor rubber mountings, release and collect mounting rubbers.

Refit
1. Fit mounting rubbers and insert compression limiters.
2. Fit new glass seal.
3. Position wiper motor assembly to tailgate, fit and tighten Torx screws to 10 Nm (7 lbf.ft).
4. Connect multiplugs.
5. Connect washer hose to wiper motor.
6. Fit wiper arm.