Arm - Wiper - Front Screen

84.15.02 Arm - Wiper - Front Screen

Remove
1. Open bonnet for access.





2. Remove nut cover on wiper arm and remove nut.
3. Remove wiper arm from spindle.

NOTE: Do not carry out further dismantling if component is removed for access only.

4. Remove wiper blade.

Refit
1. Fit wiper blade.





2. Fit wiper arm assembly to spindle, fit and finger tighten nut. Position LRT-84-001 to windscreen between points 'A' and 'B' on wiper arm, align face of wiper arm to 86 degree.





3. While maintaining the 86 degree angle, set the respective wiper arms to the dimensions shown. Passenger side 'C' = 58 mm (2.283). Drivers side 'D' = 40.5 mm (1.594).
4. Measurement must be taken from lip of the plenum glass seal to the lip of the wiper blade adjacent to wiper arm/blade pivot.
5. Tighten wiper arm nut to 34 Nm (25 lbf.ft).
6. Fit nut cover.
7. Close bonnet.