Fluid Pan: Service and Repair
44.24.05 Gasket - fluid panRemove
1. Drain gearbox fluid.
2. Remove nut securing selector lever to gearbox selector shaft and release lever.
3. Remove 2 bolts securing inhibitor switch guard and remove guard.
4. Evenly and progressively loosen and remove 22 Torx bolts from sump.
5. Remove sump and discard gasket.
Refit
1. Clean gearbox sump mating surfaces.
2. Fit new gasket to sump, position sump to gearbox.
3. Evenly and progressively tighten sump Torx bolts to 10 Nm (7 ft. lbs.).
4. Fit inhibitor switch guard, fit and tighten bolts to 10 Nm (7 ft. lbs.).
5. Fit selector lever to inhibitor switch, fit nut and tighten to 10 Nm (7 ft. lbs.).
6. Refill gearbox with transmission fluid.