Valve Assembly - Cross Link

64.50.13 Valve assembly - cross link
Do not depressurize air suspension system before raising vehicle
When removing Voss connectors from any air suspension component, the connector must be left attached to the air pipe being removed. Do not remove the connector from the air pipe. Removing the connector from the air pipe could cause the connector to scratch the pipe and increase the likelihood of leaks.

Remove
1. Raise rear of vehicle and support under body.
2. depressurize rear suspension.





3. Remove RH rear wheel arch liner.
4. Noting their fitted positions, disconnect 4 pipes from cross link valve.

CAUTION: Before disconnecting or removing components, ensure the immediate area around joint faces and connections are clean. Plug open connections to prevent contamination.

5. Disconnect multiplug from cross link valve.
6. Remove 3 bolts securing cross link valve to body.
7. Remove cross link valve assembly.

Refit
1. If fitting a new cross link valve, remove Voss air connectors from new valve.
2. Position cross link valve, fit bolts and tighten to 8 Nm (6 ft. lbs.).
3. Connect multiplug to cross link valve.
4. Connect pipes to cross link valve and tighten unions to 3.5 Nm (2.6 ft. lbs.).

CAUTION: Ensure air pipe connections are clean.

5. Fit rear wheel arch liner.
6. Pressurize suspension.
7. Remove stands and lower vehicle.