Leak Detector: Service and Repair

17.45.41 Module - Tank Leakage Diagnostic (DMTL)

Remove
1. Disconnect battery earth lead.
2. Remove RH rear wheel arch liner.





3. Disconnect multiplug from DMTL.
4. Remove bolt securing DMTL to body and release from clips.





5. Position DMTL beneath fuel tank filler neck for access. Remove and discard clip securing vent pipe to DMTL.

CAUTION: Before disconnecting any part of the fuel system, it is imperative that all dust, dirt and debris is removed from around components to prevent ingress of foreign matter into fuel system.

6. Release vent pipe and remove DMTL assembly.
7. Plug all connections.

NOTE: Do not carry out further dismantling if component is removed for access only.

8. Release air filter pipe from DMTL.
9. Remove 3 Torx screws securing DMTL to bracket and remove DMTL.

Refit
1. Position DMTL to bracket and secure with screws. Connect air filter pipe.
2. Fit vent pipe to DMTL assembly and secure with new clip.
3. Position DMTL to body, fit bolt and tighten to 10 Nm (7 lbf.ft).
4. Connect multiplug to DMTL.
5. Fit RH rear wheel arch liner.
6. Connect the battery earth lead.