Strainer - Oil Pick Up
12.60.20.01 Strainer - oil pick upRemove
1. Remove lower sump gasket.
Disassembly
1. Remove 2 bolts securing oil pick-up strainer to oil pump, remove strainer and discard O-ring.
Inspect
1. Clean oil pick up strainer and mating faces.
Reassembly
1. Fit new"O" ring to oil pump groove location, position oil pick-up strainer to oil pump.
2. Fit 2 bolts securing oil pick-up strainer to oil pump and tighten bolts to 10 Nm (7 ft. lbs.).
Refit
1. Fit lower sump gasket.
12.60.26.02 Pump - engine oil
Remove
1. Remove sump gasket.
Disassembly
1. Remove bolt securing oil pump.
2. Rotate oil pump drive chain tensioning nut anti-clockwise to release the tension.
3. Remove nut securing gear to oil pump and remove the gear.
4. Remove 2 nuts securing oil pump and remove the oil pump.
5. Remove oil feed and governing pipes from cylinder block, remove and discard 3 O-rings.
6. Remove adjusting nut from oil pump.
Inspect
1. Clean oil pipes, oil pump and mating faces.
Reassembly
1. Lubricate new O-rings. Fit oil feed pipe O-rings to groove in pump and pipe and fit governing pipe O-ring to pipe.
2. Fit oil pipes to cylinder block.
3. Fit adjusting nut fully into the oil pump.
4. Lubricate the oil pump.
5. Fit oil pump, engage oil pipes and tighten 2 nuts securing the oil pump to 23 Nm (17 ft. lbs.).
6. Clean the oil pump gear.
7. Fit oil pump gear to chain and oil pump. If necessary, rotate pump spindle to align the drive flats.
8. Fit nut securing gear to oil pump and tighten to 47 Nm (34 ft. lbs.).
9. Rotate oil pump drive chain adjuster to give a deflection of 8 mm (0.314 inch) to 12 mm (0.470) midway between sprockets.
NOTE: The oil pump chain is adjusted by turning the Allen bolt spacer which is accessed through the oil pump securing bolt hole.
10. Fit bolt securing oil pump and tighten to 23 Nm (17 ft. lbs.).
Refit
1. Fit sump gasket.