Pipes - Water Pump to Coolant Manifold
26.31.25.01 Pipe(s) - water pump to coolant manifoldRemove
1. Remove induction manifold.
Disassembly
1. Remove 6 bolts securing coolant manifold to cylinder heads.
2. Remove coolant manifold.
3. Remove and discard coolant manifold gaskets.
4. Remove 2 coolant pipes from coolant pump.
5. Discard O-rings.
Inspect
1. Clean gasket mating faces.
2. Clean O-ring grooves and ends of coolant pipes.
Reassembly
1. Lubricate new O-rings with rubber grease and fit to grooves in coolant pump and coolant manifold.
2. Fit coolant pipes to the coolant pump.
3. Position new gaskets and coolant manifold to cylinder heads, fit bolts and tighten to 10 Nm (7 ft. lbs.).
Refit
1. Fit induction manifold.