Cover - One Piece - Front Seat Cushion

Cover - One Piece - Front Seat Cushion

Service repair No - 78.30.01

Remove
1. Remove seat assembly.





2. Remove Allen bolt securing arm rest.
3. Remove armrest from boss.
4. Remove screw securing finisher on inner seat base remove finisher.
5. Remove switch pack assembly.





6. Release 3 backboard tension straps from under seat.





7. Release staples securing squab cover to lower backboard.





8. Release squab side cover from both sides of backboard.
9. Release 2 studs securing lower half of backboard.
10. Release backboard from seat.





11. Disconnect lumbar harness multiplugs from pump and valve.
12. Disconnect multiplug from heated seat circuit.





13. Release harness from retaining clip and feed through squab cover.
14. Remove 2 Torx bolts and remove squab frame from seat frame.





15. Release seat cover beading from rear of frame.
16. Release seat cover beading from sides and front of frame.





17. Remove seat cushion and cover assembly.
18. Remove 15 hog rings securing cover to cushion remove cover.

Refit
1. Position cover to cushion and secure with hog rings.
2. Position and secure cover and cushion assembly to frame.
3. Position squab frame to seat frame fit Torx bolts tighten to 25 Nm (18 ft. lbs.).
4. Route lumbar harness through squab cover and secure to frame.
5. Connect multiplug to heated seat circuit.
6. Connect lumbar harness multiplugs to pump and valve.
7. Position backboard to seat assembly fit studs securing lower of backboard.
8. Position and fit both sides of squab cover to backboard.
9. Position lower squab cover to backboard and staple.
10. Fit backboard tension straps to under seal retaining clips.
11. Fit switch pack assembly.
12. Position inner seat base finisher and secure with screw.
13. Fit armrest to boss and secure with Allen bolt, tighten to 25 Nm (18 ft. lbs.).
14. Fit seat assembly.