Finisher - Upper - Driver's Side

Finisher - Upper - Drivers Side 76.46.12

Remove
1. Remove fascia end closing panel. Closing Panel - Fascia End
2. Remove face level air vent. Fresh Air Vent - Face Level
3. Remove 'A' post upper trim finisher. Trim Finisher - 'A' Post - Upper





4. Remove 3 Torx screws securing upper finisher to fascia.
5. Release upper finisher from fascia and disconnect switch multiplug.
6. Disconnect footwell lamp multiplug.
7. Remove upper finisher.

NOTE: Do not carry out further dismantling if component is removed for access only.

6. Remove switch assembly from finisher.
9. Depress clips and remove footwell lamp assembly from finisher.

Refit
1. Fit footwell lamp assembly to finisher.
2. Fit switch assembly to finisher.
3. Connect multiplugs.
4. Fit finisher to fascia and secure with screws.
5. Fit face level air vents.
6. Fit fascia end closing panels.
7. Fit 'A' post finisher.