Arm - Wiper - Rear

84.35.01 Arm - Wiper

Service Repair No - 84.35.01

Remove
1. Remove wiper blade.
2. Remove spare wheel mounting bracket.





3. Raise nut cover on wiper arm and remove nut.
4. Release washer jet tube and remove wiper arm.

NOTE: Do not carry out further dismantling if component is removed for access only.

5. Release washer jet and washer jet tube from wiper arm.

Refit
1. Position and secure washer tube and jet to wiper arm.
2. Position wiper arm to tail door and connect washer tube.
3. Set wiper arm with tip contacting joint line between waist seal and rear door. Fit and tighten wiper arm nut to 13 Nm (10 ft. lbs.).
4. Fit wiper blade.
5. Fit spare wheel mounting bracket.