Shift Cable: Adjustments

Selector cable - adjust
Adjust
1. Remove underbelly panel.





2. Loosen trunnion nut securing inner cable to selector lever.
3. Move gear change lever into 'P' position.
4. Move selector lever on gearbox fully clockwise to engage 'P' position.
5. Pull inner cable as far forward as possible, then release. This will remove any backlash from the cable.
6. Tighten trunnion nut to 6 Nm (4 ft. lbs.).
7. Fit underbelly panel.
8. Move selector lever through its working arc; from 'P' to '2' and back to 'P', checking that all gear positions are correctly selected.
9. Check that the engine will start in 'P' and 'N' positions and is inhibited when drive positions are selected.