Harmonic Balancer - Crankshaft Pulley: Service and Repair

Pulley - Crankshaft

Service Repair No - 12.21.01

Remove
1. Remove underbelly panel.
2. Remove RH front road wheel.





3. Remove 3 bolts securing RH splash shield to body and remove shield.





4. Using a 3/8 square drive socket bar, raise ancillary drive belt tensioner and release drive belt from crankshaft pulley.
5. Assemble LRT-12-161 to LRT-12-199 and secure with clamp bolt.





6. Insert LRT-12-161 with LRT-12-199 into crankshaft pulley, loosen and remove pulley bolt.
7. Remove special tool from crankshaft pulley and remove crankshaft pulley.

Refit
1. Clean crankshaft pulley and crankshaft gear mating faces.
2. Fit crankshaft pulley to crankshaft gear and ensure that the indent on pulley locates over the lug on crankshaft gear.
3. Fit crankshaft pulley bolt and washer, position LRT-12-161 with LRT-12-199 into crankshaft pulley. Tighten pulley bolt to 160 Nm (118 ft. lbs.).
4. Remove special tool from crankshaft pulley.
5. Ensure drive belt is located on ancillary pulleys, raise belt tensioner and fit drive belt to crankshaft pulley,
6. Fit splash shield and secure with bolts.
7. Fit RH road wheel and tighten nuts to 115 Nm (85 ft. lbs.)
8. Fit underbelly panel.