Upper Side Moulding / Trim: Service and Repair

76.43.68 Moulding - Roof - 5 Door

Remove
1. Remove tail door glass side finisher.





2. Remove roof finisher caps or roof rack side rail.
3. Using a suitable hooked tool in the front foot hole of the roof finisher, slide the finishers 2 forward clips rearward from the roof channel.
4. Slide the clip rear of the foot hole forward from the roof channel.
5. Slide the remaining 7 clips from the roof channel.
6. Remove nut securing rear end of roof finisher and remove finisher.
7. Remove clips from roof finisher.

Refit





1. Fit clips to roof finisher.
2. Fit finisher to roof channel with forward 2 clips.
3. Slide finisher to align with screen. Feed forward clip below screen seal.
4. Fit remaining clips to roof channel.
5. Fit nut and secure rear end of finisher.
6. Ensure full length of finisher is correctly seated in roof channel.
7. Fit roof finisher caps or roof rack side rail.
8. Fit tail door glass side finisher.