Trim Casing - Rear Door

76.34.04 Trim Casing - Rear Door - From 04MY

Remove





1. Remove screw securing door release escutcheon and remove escutcheon.





2. Release and remove door pull finisher from door pull.
3. Remove 3 screws securing door pull to door assembly.





4. Release trim casing from door assembly.





5. Disconnect multiplug from door tweeter.
6. Disconnect multiplug from window lift switch and remove trim casing.

NOTE: Do not carry out further dismantling if component is removed for access only.





7. Release 2 clips and remove window lift switch finisher from trim casing.





8. Remove locking ring securing tweeter to trim casing and remove tweeter.





9. Remove foam pad from sill button guide.
10. Release retainer and remove sill button guide.
11. Note the fitted position of the 2 long trim studs and remove 9 trim studs from trim casing.
12. Release and remove locking ring securing door pull to trim casing.
13. Remove 2 plastic rivets securing door pull to trim casing and remove door pull.

NOTE: Plastic rivets are used for production purposes only. Screws should be used to retain all parts previously held in place with plastic rivets.

Refit
1. Fit door pull to trim casing and secure with screws and locking ring.
2. Fit trim studs to casing.
3. Fit sill button guide to trim casing and secure with retainer.
4. Fit foam pad to sill button guide.
5. Fit tweeter to trim casing and secure with locking ring.
6. Fit and secure window lift switch and finisher to trim casing.
7. Connect multiplugs to window lift switch and door tweeter.
8. Position trim casing, align fasteners with holes in door and press firmly into position.
9. Fit and tighten screws securing door pull to door assembly.
10. Fit and secure door pull finisher to door pull.
11. Fit door release escutcheon to trim casing and secure with screw.