Seal - Front Output Shaft

Seal - Front Output Shaft

Service repair No - 41.20.51

Remove
1. Position vehicle on 4 post ramp.
2. Remove front propeller shaft.





3. Restrain transfer box drive flange using tool LRT-51-003. Remove and discard drive flange nut, remove and discard steel and felt washers.





4. Using tool LRT-99-500 if necessary, remove drive flange from transfer box.





5. Remove seal from transfer box.

Refit
1. Clean seal mating faces.
2. Lubricate seal with gearbox oil.





3. Fit new seal using tool LRT-41-012.





4. Position drive flange, fit new felt and steel washers.
5. Position tool LRT-51-003 and tighten new drive flange nut to 148 Nm (109 lbf.ft).
6. Fit propeller shaft.
7. Top-up transfer box oil.