Rear Bumper: Service and Repair

76.22.15 Bumper Assembly - Rear - From 03MY

Remove

1. Remove both rear tail lamps.







2. Disconnect park distance control harness multiplug.







3. Release rear lamp harness clips.







4. Remove 2 bolts securing bumper.
5. With assistance remove bumper.

NOTE: Do not carry out further dismantling if component is removed for access only.







6. Remove 7 bolts and 5 screws securing closing panel and remove panel.







7. Disconnect 4 park distance control sensor harness multiplugs and remove 6 clips retaining harness.
8. Release 3 clips retaining harness and remove harness.
9. Noting their fitted positions, release and remove 4 park distance control sensors and sensor housings.

Refit

1. Fit sensor housings to bumper, ensuring lugs on housings are aligned with cut-outs in bumper.
2. Fit and secure sensors to housings.
3. Fit harness, secure with clips and connect multiplugs
4. Fit closing panel and secure with bolts and screws.
5. With assistance, fit bumper assembly to body.
6. Fit bolts securing bumper and tighten to 45 Nm (33 lbf.ft).
7. Secure rear lamp harness clips and connect park distance control sensor harness multiplug.
8. Fit both rear tail lamps.