Motor - Wiper - Rear

Motor - Wiper

Service Repair No - 84.35.12

Remove
1. Remove rear wiper arm.
2. Remove tail door plastic sheet.





3. Remove spindle nut and flat washer and discard rubber seal.





4. Disconnect multiplug from rear wiper motor.
5. Remove 2 bolts securing wiper motor to tail door.
6. Remove wiper motor.

NOTE: Do not carry out further dismantling if component is removed for access only.





7. Remove and discard spindle sealing washer.
8. Remove motor water shield.
9. Remove 3 bolts securing mounting plate to wiper motor.
10. Release multiplug and remove mounting plate.

Refit
1. Position mounting plate, tighten bolts and secure multiplug.
2. Fit motor water shield and new sealing washer to spindle.
3. Fit wiper motor and tighten bolts to 5 Nm (3.5 ft. lbs.).
4. Connect multiplug to rear wiper motor.
5. Fit NEW rubber seal to wiper motor spindle.
6. Fit flat washer and tighten spindle nut to 5 Nm (3.5 ft. lbs.).
7. Fit tail door plastic sheet.
8. Fit wiper arm.